All articles published by MDPI are made immediately available worldwide under an open access license. No special permission is required to reuse all or part of the article published by MDPI, including figures and tables. For articles published under an open access Creative Common CC BY license, any part of the article may be reused without permission provided that the original article is clearly cited. For more information, please refer to https://www.mdpi.com/openaccess.
Is this you? As a journalist, you can create a free Muck Rack account to customize your profile, list your contact preferences, and upload a portfolio of your best work.
Claim your profile
Articles by Susana Devesa
Green Synthesis of CuO Nanoparticles-Structural, Morphological, and Dielectric Characterization
All articles published by MDPI are made immediately available worldwide under an open access license. No special permission is required to reuse all or part of the article published by MDPI, including figures and tables. For articles published under an open access Creative Common CC BY license, any part of the article may be reused without permission provided that the original article is clearly cited. For more information, please refer to https://www.mdpi.com/openaccess.
Comprehensive Characterization of Bi1.34Fe0.66Nb1.34O6.35 Ceramics: Structural, Morphological, Electrical, and Magnetic Properties
All articles published by MDPI are made immediately available worldwide under an open access license. No special permission is required to reuse all or part of the article published by MDPI, including figures and tables. For articles published under an open access Creative Common CC BY license, any part of the article may be reused without permission provided that the original article is clearly cited. For more information, please refer to https://www.mdpi.com/openaccess.
Enhancing Solar Absorption with Double-Layered Nickel Coatings and WS2 Nanoparticles on Copper Substrates
1. Introduction The Sun, which is the primary source of energy for the Earth system, provides an average of about 340 watts of energy per square meter of the Earth’s surface, accounting for both day and night as well as seasonal variations. This energy reaches the Earth mainly as visible light, but it also includes infrared and ultraviolet radiation and other wavelengths of the electromagnetic spectrum.
Dielectric Characterization of Solutions of Galactomannan Extracted from Adenanthera pavonina L.: Effects of Purification and Ethanol Concentration
All articles published by MDPI are made immediately available worldwide under an open access license. No special permission is required to reuse all or part of the article published by MDPI, including figures and tables. For articles published under an open access Creative Common CC BY license, any part of the article may be reused without permission provided that the original article is clearly cited. For more information, please refer to https://www.mdpi.com/openaccess.
Influence of Polymeric Blends on Bioceramics of Hydroxyapatite
3.3. Thermal Analysis To study the thermal behavior of HAP and the GC blend, thermogravimetry and differential scanning calorimetry measurements were performed and are depicted in Figure 5 and Figure 6. The TG curve shows a three-stage weight loss at the temperature ranges of 20–100, 100–300 and 300–500 °C, approximately. In the first stage, the weight loss is due to the evaporation of adsorbed water [72,73].
A 3D-Printed Ceramics Innovative Firing Technique: A Numerical and Experimental Study
This is an early access version, the complete PDF, HTML, and XML versions will be available soon.
Dielectric Stability of Triton X-100-Based Tissue-Mimicking Materials for Microwave Imaging
3. Results The measured dielectric properties of the tissue-mimicking materials are shown in Figure 3. Besides the measured values, and for comparison, the values proposed by the IT’IS [38] database and calculated using the Cole–Cole model are also presented. As previously mentioned, the four-pole Cole–Cole model was adopted, with the optimized parameters obtained from [15].
Structural, Morphological and Dielectric Characterization of BiFeO3 Fibers Grown by the LFZ Technique
Open AccessArticle by Marina Vieira Peixoto 1, Florinda Mendes Costa 1, Susana Devesa 1,2,* and Manuel Pedro Fernandes Graça 1,* 1 I3N-Physics Department, University of Aveiro, Campus Universitário de Santiago, 3810-193 Aveiro, Portugal 2 CEMMPRE, Centre for Mechanical Engineering, Materials and Processes, Department of Mechanical Engineering, University of Coimbra, Rua Luís Reis Santos, 3030-788 Coimbra, Portugal * Authors to whom correspondence should be addressed.
Influence of the Preparation Method on the Structural, Morphological and Dielectric Properties of FeNbO4 Ceramics
3.2. Morphological Characterization Figure 7 shows the SEM micrographs of the samples prepared via the CG method. The HT 400 and HT 500 samples were composed of particles with an angular shape and significant heterogeneity in terms of size. The heat treatment at 600 °C promoted a substantial change in the morphology of the material since both the shape and size of the grains were very similar in this sample.
Show More
loading
Actions
Is this you?
As a journalist, you can create a free Muck Rack account to customize your profile, list your contact preferences, and upload a portfolio of your best work.Get in touch with Susana
Contact Susana, search articles and posts on X, monitor coverage, and track replies from one place.
Learn more about Muck Rack