Skip To Main Content
Ioan Barbur on Muck Rack

Ioan Barbur

As seen in: MDPI, Dialnet - Universidad de La Rioja
Is this you? As a journalist, you can create a free Muck Rack account to customize your profile, list your contact preferences, and upload a portfolio of your best work. Claim your profile

Get in touch with Ioan

Contact Ioan, search articles and posts on X, monitor coverage, and track replies from one place.

Learn more about Muck Rack

Actions

Share this page

Is this you?

As a journalist, you can create a free Muck Rack account to customize your profile, list your contact preferences, and upload a portfolio of your best work.
Claim your profile

Articles

Diseño asistido por biblioteca: el flujo de trabajo y los momentos críticos

|
By Florin Cofar, Ioan Barbur, Gustavo Giordani, Marcelo GIORDANI
| Dialnet - Universidad de La Rioja
Ayuda Buscar en la ayuda Buscar en la ayuda Diseño asistido por biblioteca: el flujo de trabajo y los momentos críticos Autores: Florín Cofar, Ioan Barbur, Gustavo Giordani, Marcelo Giordani, Ioan Cofar, Eric van Dooren, Ioana Popp, Paul Ficut Localización: Quintessence: Publicación internacional de odontología, ISSN 0214-0985, Vol. 12, Nº. 4, 2024, págs.
Open in Who Shared Issue with article?

Condylar Remodeling and Skeletal Changes Following Occlusal Splint and Manual Therapy: A Cone Beam Computed Tomography Study in Temporomandibular Disorders

|
By Ioan Barbur, Alina Ban, Marius Negucioiu, Smaranda Buduru
| MDPI
All articles published by MDPI are made immediately available worldwide under an open access license. No special permission is required to reuse all or part of the article published by MDPI, including figures and tables. For articles published under an open access Creative Common CC BY license, any part of the article may be reused without permission provided that the original article is clearly cited. For more information, please refer to https://www.mdpi.com/openaccess.
Open in Who Shared Issue with article?

Biomedicines | Free Full-Text | Statistical Comparison of the Mechanical Properties of 3D-Printed Resin through Triple-Jetting Technology and Conventional PMMA in Orthodontic Occlusal Splint Manufacturing

|
By Ioan Barbur, Horia Opris, Bogdan Crisan, Stanca Cuc
| MDPI
4. Discussion Regarding the compression, our results concluded that the control material (PMMA) has a statistically significant higher Young’s modulus of compression and tensile strength (p < 0.05). Concerning the flexural tests, statistically significant and higher results were shown to be better for the control samples (PMMA) for load at break. Maximum bending stress at maximum load (MPa) is statistically more significant for the 3D-printed samples.
Open in Who Shared Issue with article?
See all 5 licensed articles (8 Total)