Yinxia Zhang

ABSTRACT Slender workpieces are characterized by high load-carrying capacity and light weight and are commonly used in the manufacture of drive shafts and key aerospace components. However, they generally have low stiffness, and chatter often occurs during the cutting process. Even with finish-turning, it is difficult to achieve ideal surface integrity, which affects the service property of the workpiece. Therefore, finish-turning experiments were conducted on 18CrNiMo7–6 steel slender workpieces.

1. Introduction Dry hard turning (DHT) technology is widely used to process materials with a hardness above 45 HRC [1,2,3]. When the DHT process is applied in the finishing operation, a high cutting speed and large depth of cut are generally used to remove materials, and ideal machining quality and accuracy are also obtained [3].

A highly stable elastic electrode via direct covalent crosslinking for strain sensors Linping Wang, Benlin Hu, Fengyuan Zhang, Yinxia Zhang, Junming Li, Tianhua Xu and Run-wei Li Abstract Electrodes are essential components in electronic devices. One challenge in developing wearable electronics involves obtaining elastic electrodes with high mechanical and electrical stability.